RF connectors used in communications, medical, aerospace and other fields are not just RF connectors, they are also used with cable assemblies to complete a signal bridge. Generally, the RF connector has two forms of use: one is directly mounted on the instrument panel or the printed circuit board, and the other is a structure in which the RF coaxial cable is conn...
What are the main parts of the RF connector? Where is the application? Now introduce the relevant structural knowledge about RF connectors. The main components of the RF coaxial connector are outer conductor, insulator, center pin, nut case, buckle, waterproof ring, dust cap, etc. First, the outer conductor acts as a grounding shield. The materi...
With the rapid growth of consumer electronics, automotive electronics, communication terminal market and the continuous transfer of SMP Connector production to Asia especially China, Asia has become the most promising place in the SMP connector market, and China will become the global growth of SMP RF connector. Fast and large capacity markets. It is estimated that the growth rate of...
A typical VSWR for a low-cost 3 GHz test cable and when used at higher frequencies requires a microwave test RF cable assembly, which means that the user has to pay a higher cost. This is because the design and manufacturing philosophy of microwave cables is different from that of conventional cables. For example, microwave cables usually use multiple layers of sh...
An RF connector, also known as an RF connector, is generally considered to be an element attached to a cable or mounted on an instrument as an electrical connection or separate component of the transmission line. The RF connector is a mechatronic product that serves primarily as a bridge. The following is a description of the RF connector code . N connectors: Threaded R...
The MMCX interface is a type of coaxial connector. It was developed in 1990 and uses a plug-in connection to rotate 360 degrees. Usually its characteristic impedance is 50 ohms. The MMCX connector is commonly found on the antenna interface of a PC's wireless PC card, and on the GPS communication antenna jacks of some PDAs and GPS navigation devices. On some of the in-ear he...
Here are well-known SMA connectors in the RF connector, BNC connectors, which are far more than these connectors in the RF connector. There are basic components of the RF connector, including the outer conductor, the insulator, the center pin, and the nut housing, buckle, waterproof ring, dust cap, etc. The following takes you through the structure and classification of the RF c...
In a variety of RF coaxial connectors are chosen to have different coatings, why should it be plated? What factors should be considered for plating? What is the plating material? This pile of questions, is not very Mongolian! Today summarized the materials and problems of the RF coaxial connector selection coating. Let's take a look! In the electrical and electronic ind...